BMW E90 320I Cranking but NO START BMWFanatics?

BMW E90 320I Cranking but NO START BMWFanatics?

WebCrank the engine and look for a blue/white spark. Remove the fuel rail and pull pout the injectors out ot the throttle bodies, but keep them in the fuel rail. Crank the engine again and watch if the injectors fire. 1&2 fire simultaneously and nr 3 &4. WebJan 4, 2024 · Have someone crank the engine and watch for the spark between the screwdriver and the intake manifold. A word of caution — ignition coils produce high … ac origins armas WebFeb 11, 2011 · (coil wire near ground yielded a blue spark for a split second last night) Update; changed out the computer with a known good one from another ce.ar. No … WebHi team. I'm working on 1989 e30 m20b25 and it cranks but no start. Initially thought it would be the dead fuel pumps. Have tested with 12v battery directly to the pump and and it was dead. Since then, replaced the fuel pump, fuel filter, fuel pump relay, main relay, and still not starting. ac origins audio bug WebAug 20, 2024 · Hey guys, I’m trying to get my m3 back on the road after rebuilding the engine and I’ve ran into an issue getting it to start. It cranks really slow and weak a few times than stops cranking. Things I’ve replaced: new charged battery, new alternator, new spark plugs and wires, new ignition coil, new cap and WebApr 22, 2009 · new plugs, leads, distributer cap rotor arm and battery. when you check the coil with the ignition on there is 12.17 volts and when winding over its 10.47 volts and same with the main ht lead but when you check the plug leads when trying to fire the engine theres no spark or voltage. i,ve even change all the relays and check all fuse,s. really ... aquatic weed harvester near me WebSep 11, 2008 · So, the following are possibilities: 1) the fuel pump is not providing adequate fuel. fuel pump is not running after it is done cranking (ECU problem) 2) ECU is not telling the injectors to turn on (ECU problem if there is spark, sensor problem if not) 3) the injectors are not getting the signal to open (bad wiring because there is no connector ...

Post Opinion